Correct operations of changing diapers for the baby

1. Put new baby diaper

Put the baby on the baby changing mat, spread out the new diapers and raise the inside frill.  Gently support the baby's side body with your arm, then lay the new diaper flat under the baby's butt. Place the back half of the diaper on from your baby's waist to above the navel.

2. Unfasten the diaper baby is wearing and tear the tape off both side. But don't put it away immediately in case baby’s sudden urination.

3. Gently draw out the used diaper

Using one hand hold the baby's two legs together, gently lifted  and do not lift too high hurt baby's waist. Wipe baby's butt’s dirt with wet wipes to prevent urine residue caused by red butt. If baby has red butt, it is not recommended to use wet wipes to wipe. please with dry paper.After wiping, drawl out the used diaper.

4. Clean the butt area covered by the used diaper

Wring out the towel soaked in warm water, gently wipe down the area covered by the diaper, then apply butt cream to the baby and let dry.

5. Put on a new diaper to the baby

According to baby boy or baby girl slightly adjust the diaper, baby boy in front of a little higher, baby girl behind a little higher, this adjustment effectively prevent diaper leakage. Pull up the front of the diaper gently. while pressing the edge of the diaper, pulling the waist line and then sticking adhesive tape evenly on both sides.

6. Check the tightness and comfort of the anti-side leakage strip.

After the Velcro is stick on, put your finger into the gap between the diaper and the baby's waist to see the tightness. Generally, the looseness of one finger can be put into the diaper. Use your hand to stroke the edge of the anti-side leakage of the leg.